Assembly Instructions

1 1 Unpack contects. 2. Lay parts A, A, and B on flat work surface.		2 1. Insert a a bead of glue in the part B along the entire recess
3 1. Insert part A into part B on both ends		4 1. Part B laying flat on work surface 2. Hammer parts A into part B on both ends until the have a "snug" fit
5 1. Lay a bead of glue in the long groove of part B		6 1. Lay part C flat on the work surface
7 1. Keep parts A and B assembeled on the work surface 2. Insert part C into parts A & B		8 1. Make sure that C fits firmly into A & B
9 1. Apply a bead of glue into the loose part B		10 1. Line up, and attach part B to the A,A,B, and C assemblyPress firmly once inserted.
11 1. Using a rubber mallot, hammer the casket assembly to a tigh fit		12 1. Once the casket is hammer to a snug fit, apply small amounts of glue into the pre drilled assembly holes
13 1. After the glue has been inserted into the assembly holes, insert and hammer in the provided dowels. 2.The dowels must be knocked in to a flush fit 3. Flip the assembly, and insert/hammer the dowels on the opposite side.		14 1. Let the casket assembly dry for 24 hours. 2. Do not use glue Apply lid part C onto the assembly to verify the fit.
15 1. This is how the casket assembly should look like up to this point		16 1. Attach lid part D, locking it under part C
17 1 Fully assembled product

Sitemap